Addonics Technologies Computer Hardware RT54S2HMEU User Manual

ADDONICS TECHNOLOGIES  
Model: RT54S2HMEU  
I.  
Installing drive into the RAID Tower V  
Step 1  
III. Power on/off control  
Turn on the power to the RAID Tower Mini by pressing the power  
button on the front. The power LED light should lit indicating the power  
is on.  
Mount 2.5” SATA hard disk drivs into the  
drive tray and slide the tray into the drive  
bay.  
Step 2  
Using 3.5” SATA hard disk drive, slide the  
drive into the drive bay. Close the front  
panel and using the key provided, turn the  
key lock to the Lock position. This will secure the drive and turn on the  
power to the hard drive.  
Power LED  
Two HPMs are mounted on the tower. One HPM is connected to the  
disk array for 2.5” SATA drives. The other HPM is connected to the 4  
Snap-in Mobile rack for 3.5” SATA drives.  
Power Switch  
Note: It is recommended to fill up the RAID Tower V with SATA drives  
from left to right and top to bottom. This is to help in identifying which  
drives connect to which ports for easier troubleshooting.  
HPM 1 (Top disk array)  
(LED 1) HPM Health  
(LED 2) eSATA Status  
(LED 3) USB Status  
II. Connecting the power cable and RAID Tower V to the  
computer  
a. Connect the power cord provided from the wall outlet to the back of  
the RAID Tower.  
HPM 2 (Snap-in racks)  
(LED 1) HPM Health  
(LED 2) eSATA Status  
(LED 3) USB Status  
b. Make sure the power is off (power LED light should be off).  
c. Connect either the provided USB or eSATA cable from the back of  
the RAID Tower to the computer. We recommend connecting the  
eSATA port for best performance if this port is available on your  
computer.  
II.  
Photo identifying SATA ports on HPM  
RAID  
setting  
button  
RAID config  
rotary switch  
PM Health LED  
eSATA LED  
USB LED  
USB port  
SATA  
Port 4  
eSATA port  
SATA  
Port 1  
Pin 1  
LED pins  
Power Switch  
Power Connector  
SATA  
Port 2  
SATA  
Port 3  
Rotary Switch  
USB 5-Pin Header  
Pin 1  
IV. Setting RAID on the HPM  
1. Attach the SATA hard drives (up to 4) to the SATA ports on the  
Hardware Port Multiplier (HPM) using SATA cables. It is  
recommended to connect drives to the SATA ports 1 to 4  
successively.  
2. Set the Rotary switch to the RAID mode required.  
3. Push the RAID setting button with a ballpoint pen tip while the HPM  
is turned off.  
LED Pin Assignment  
Use a ballpoint pen  
tip to press the  
RAID Setting Button  
 

321 Studiosr QW2S User Manual
AD Blood Pressure Monitor UA 767 Plus BT User Manual
Agilent Technologies Welding System Agilent 33220A User Manual
Aiphone Home Security System JB DVF HID I User Manual
Amana Refrigerator A8RXNGMW User Manual
Atlona Car Amplifier AT PA100 G2 User Manual
Audiovox Automobile Alarm APS 596 User Manual
AVerMedia Technologies DVR NV 1000 User Manual
Avocent Network Router Cyclades PR2000 User Manual
Axor Indoor Furnishings 92720000 User Manual